(Created page with "{{DISPLAYTITLE:Orange Pi 3}} == Description == Official website : ["http://www.orangepi.org/Orange Pi 3/" http://www.orangepi.org/Orange Pi 3/] (Dev/OPi/Opi3/Backup_presen...")
(3 intermediate revisions by the same user not shown)
Line 2:
Line 2:
== Description ==
== Description ==
Official website : ["http://www.orangepi.org/Orange Pi 3/" http://www.orangepi.org/Orange Pi 3/] ([[Dev/OPi/Opi3/Backup_presentation|Backup]])<br />
Official website : [http://www.orangepi.org/Orange%20Pi%203/ orangepi.org/Orange Pi 3/] ([[Dev/OPi/Opi3/Backup_presentation|Backup]])<br />
The OrangePi 3 board is an Open-source Single Board Computer (SBC) of 93x60mm created and sold by Xunlong.
The OrangePi 3 board is an Open-source Single Board Computer (SBC) of 93x60mm created and sold by Xunlong.
== Base system ==
== Base system ==
* [[Dev/OPi/OPi3/From_Scratch|Create initial system from scratch (sources)]]: all the steps, using u-boot and Linux kernel sources, and a guide to create a minimal system using either Busybox or Devuan.
* [[Dev/OPi/OPi3/From_Scratch|Create initial system from scratch (sources)]]: all the steps, using u-boot and Linux kernel sources.
* [[Dev/Embedded/Rootfs|Rootfs guide]] to create either a minimal system using Busybox or a full Devuan GNU/Linux system.
* The "SD card creation" section from the [[Dev/OPi/OPi3/From_Scratch|"from scratch" page]] : also provides information to use u-boot, kernel, and Devuan root filesystem I built. <br />
* The "SD card creation" section from the [[Dev/OPi/OPi3/From_Scratch|"from scratch" page]] : also provides information to use u-boot, kernel, and Devuan root filesystem I built. <br />
You can get the images here: [http://data.nathael.net/Dev/OPi/OPi3/ Images for Orange Pi 3 board].
You can get the images here: [http://data.nathael.net/Dev/OPi/OPi3/ Images for Orange Pi 3 board] (Not yet available as my ADSL upload would not support it :( ).
== Connection and startup ==
== Connection and startup ==
Line 22:
Line 23:
=== SD card boot ===
=== SD card boot ===
The OrangePi 3 board boots from the SD card which has to be prepared following specific steps. Follow the "SD card creation" section from the [[Dev/OPi/OPi3/From_Scratch|"from scratch" page]]
The OrangePi 3 board boots from the SD card which has to be prepared following specific steps. Follow the "SD card creation" section from the [[Dev/OPi/OPi3/From_Scratch|"from scratch" page]]
=== X11 ===
==== Liens avec quelques pistes pour améliorer ====
On the J3 connector (3 pins male 2.54mm, next to the power button and micro USB port, pin 1 on the power button side) :
pin 1 - GND : Black
pin 2 - UART RX : Orange
pin 3 : UART TX : Yellow
SD card boot
The OrangePi 3 board boots from the SD card which has to be prepared following specific steps. Follow the "SD card creation" section from the "from scratch" page
