(One intermediate revision by the same user not shown)
Line 10:
Line 10:
* [[Dev/Embedded/Rootfs|Rootfs guide]] to create either a minimal system using Busybox or a full Devuan GNU/Linux system.
* [[Dev/Embedded/Rootfs|Rootfs guide]] to create either a minimal system using Busybox or a full Devuan GNU/Linux system.
* The "SD card creation" section from the [[Dev/OPi/OPi3/From_Scratch|"from scratch" page]] : also provides information to use u-boot, kernel, and Devuan root filesystem I built. <br />
* The "SD card creation" section from the [[Dev/OPi/OPi3/From_Scratch|"from scratch" page]] : also provides information to use u-boot, kernel, and Devuan root filesystem I built. <br />
You can get the images here: [http://data.nathael.net/Dev/OPi/OPi3/ Images for Orange Pi 3 board].
You can get the images here: [http://data.nathael.net/Dev/OPi/OPi3/ Images for Orange Pi 3 board] (Not yet available as my ADSL upload would not support it :( ).
== Connection and startup ==
== Connection and startup ==
Line 23:
Line 23:
=== SD card boot ===
=== SD card boot ===
The OrangePi 3 board boots from the SD card which has to be prepared following specific steps. Follow the "SD card creation" section from the [[Dev/OPi/OPi3/From_Scratch|"from scratch" page]]
The OrangePi 3 board boots from the SD card which has to be prepared following specific steps. Follow the "SD card creation" section from the [[Dev/OPi/OPi3/From_Scratch|"from scratch" page]]
=== X11 ===
==== Liens avec quelques pistes pour améliorer ====
On the J3 connector (3 pins male 2.54mm, next to the power button and micro USB port, pin 1 on the power button side) :
pin 1 - GND : Black
pin 2 - UART RX : Orange
pin 3 : UART TX : Yellow
SD card boot
The OrangePi 3 board boots from the SD card which has to be prepared following specific steps. Follow the "SD card creation" section from the "from scratch" page
